Lightmaxx VECTOR Spot 200 Bedienungsanleitung Seite 29

Mounting option:
This device can be positioned and fixed in all directions of the stage by a clamp. The locking system
facilitates attachment to the bracket.
Note! Two clamps are required to secure the unit. Each clamp is secured by a 1/4 lock. The lock
can only be locked clockwise.
Note! Always attach a safety rope with sufficient load capacity to the additional opening of the
mounting block.
Check whether the fastening clip is damaged. Ensure that the architecture can withstand ten times
the weight of all equipment, clamps, wiring and other additional devices.
Clamping screws must be firmly tightened. Use an M12 screw (strength class 8.8 or higher) to
secure the clamp, then tighten the nuts.
Align the two suspension points on the underside of the clamp. Fasten the lock at the bottom, lock
the two levers by turning them 1/4 clockwise. Then install the other clamp.
Install a safety rope with sufficient load-bearing capacity.
Make sure that the pan/tilt lock is not locked. Maintain a distance of more than 12M between the
light source and combustible materials.
29