Troubleshooting - Saeco PICCINA Bedienungsanleitung

E N
Problem encountered
The machine does not turn on.
The machine requires a lot of time to heat up.
The pump is very noisy.
It is not possible to insert the pod holder
The coff ee is cold.
The coff ee is brewed too fast; the brewed coff ee
is not creamy.
Coff ee is not brewed or brewed in drips only.
Hot water/steam not dispensed.
The milk does not froth.
Please contact a Saeco service centre for any faults not covered in the above table or when the suggested solutions do not solve the problem.
TECHNICAL SPECIFICATIONS
·
Nominal Voltage - Power Rating - Power Supply:
See label on the appliance
· Size: Height Width
318 mm 187 mm
· Weight: about 5 kg
· Water tank: about 1.4 litres - Removable
· Materials used for the chassis: Thermoplastic material

TROUBLESHOOTING

Possible causes
» The machine is not connected to the electric
network.
» The appliance is full of limescale.
» No water in the tank.
» The tank has been fi lled without priming the
water circuit.
» Pod holder in the wrong position.
» Pod inserted incorrectly.
» The indicator light was off when the coff ee
brew button was pressed.
» Pod already used.
» Clogged pod holder.
» The water circuit is empty.
» Clogged steam wand.
» Not suitable milk.
» The milk is too hot.
» The indicator light was not steady on.
·
Power cord length 1.2 m
· Control panel: On the upper part
Depth · Boiler: Aluminium
276 mm
·
Safety devices: Pressure safety valve.
· Double thermal fuse
2006/42 EC - 2004/108 EC - 2006/95 EC
Solution
» Connect the machine to the electric network.
» Contact after-sales service.
» Descale the machine.
» Refi ll with fresh drinking water.
» Carry out the priming of the water circuit (see section
"Priming the water circuit").
» Change the pod holder position.
» Remove the pod and place it again.
» Wait until the indicator light turns on.
» Remove the pod holder and place a new pod.
» Carry out the dispensing spout wash cycle (see
MAINTENANCE AND CLEANING).
» Carry out the priming of the water circuit (see Section
"Circuit Priming").
» Clean the spout with a needle (the machine needs to be
unplugged and the steam/hot water dispensing knob
needs to be closed).
» Use fresh, partially skimmed milk.
» Use milk at refrigerator temperature.
» Press the steam button and wait for the indicator light
to turn on.