Klarstein 10033036 Bedienungsanleitung Seite 32

EN
32
Problem Possible causes
Fan noise com- A cooling fan built into your
ing from induction hob has come on to
the induction prevent the electronics from
hob. overheating. It may continue to
run even after you ve turned the
induction hob off.
Pans do not 1. The induction hob cannot
become hot. detect the pan because it
is not suitable for induction
cooking.
2. The induction hob cannot de-
tect the pan because it is too
small for the cooking zone or
not properly centred on it.
The induction Technical fault.
hob or a
cooking zone
has turned
itself off
unexpectedly,
a tone
sounds and an
error
code is dis-
played.
Error codes
Code Reason
E0 Use of wrong, too small a pot
E2 NTC Open/Short Circuit
E3, E4 Voltage too low, too high
E5 Ceramic Plate is over heated
E6 Overheat Protection
What to do
This is normal and needs no
action. Do not switch the power
to the induction hob off at the
wall while the fan is running.
Use cookware suitable for
induction cooking. Centre the
pan and make sure that its base
matches the size of the cooking
zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
Solution
Use a correct pot
Please return the device for
repair
Connect the device to a correct
power outlet
Allow the device to cool down,
turn it off completely and then
on again
Allow the device to cool down,
turn it off completely and then
on again