Cleaning And Maintenance - Klarstein 10030001 Anschluss- Und Anwendungshinweise

Reinigung des Filtergitters.
• Removing the filters as the instruction in picture below.
• Method 1:Soak them for about 3 minute in hot water (40-50 degrees) with a grease-loosening detergent
then brush it gently with a soft brush. Please do not apply too much pressure, avoid damaging it.
• Method 2: It can be put into a dishwasher with detergent, set the temperature at around 60 degrees.
• Please do not use abrasive detergent for it will damage the hood.
• Make sure that the hood is shut off before cleaning.
Changing the light
• Before changing the lights, ensure that the appliance is not live (i.e., ensure that you have switched it off
at the wall switch).
• Press the handle of the Aluminium filter towards the rear part of the unit until it is released from the front
housing, and remove it by pressing downwards.
• Change the bulb using only Max. 28W E14 bulb Replace the Al filter to the original position.

Cleaning and Maintenance

16