Adjustment Of Minimum Level - Electrolux EKK6450AO Benutzerinformation

30 www.electrolux.com
4. Assemble the parts, follow the same
procedure backwards.
5. Replace the rating plate (it is near the
gas supply pipe) with the one for the
new type of gas supply. You can find
this plate in the package supplied
with the appliance.
If the supply gas pressure is changeable
or different from the necessary pressure,
you must fit an applicable pressure ad-
juster on the gas supply pipe.
13.6 Adjustment of minimum
level
To adjust the minimum level of the burn-
ers:
1.
Light the burner.
2. Turn the knob on the minimum posi-
tion.
3. Remove the knob.
4. With a thin screwdriver, adjust the by-
pass screw position (A).
• If you change from natural gas to liquid
gas, fully tighten the adjustment screw
in.
• If you change from liquid gas to natural
gas, undo the by-pass screw approxi-
mately 1/4 of a turn.
WARNING!
Make sure the flame does not go
out when you quickly turn the
knob from the maximum position
to the minimum position.
13.7 Levelling
Use small feet on the bottom of appliance
to set the appliance top surface level with
other surfaces.
A
13.8 Anti-tilt protection
CAUTION!
You must install the anti-tilt pro-
tection. If you do not install it, the
appliance can tilt.
Make sure you install the anti-tilt
protection at the correct height.
1.
Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 77 mm
down from the top surface of the ap-
pliance and 49 mm from the side of
the appliance into the circular hole on
a bracket (see fig.). Screw it into the
solid material or use applicable rein-
forcement (wall).
3. You can find the hole on the left and
right side on the back of the appli-
ance.
The appliance is delivered with a
left-hand bracket. You can buy a
right-hand bracket at your local
dealer.
Lift the front of the appliance (1) and
put it in the middle of the space be-
tween the cupboards (2). If the space
between the bench cupboards is
larger than the width of the appliance,
you must adjust the side measure-
ment to centre the appliance.
Make sure that the surface behind the
appliance is smooth.