Remedy Of Faults - Oase ProMax Garden Classic 3000 Gebrauchsanleitung

Shutting down the pump
How to proceed:
1. Switch off the pump
2. Disconnect the power plug.
3. Depressurise the pressure line by open-
ing the water withdrawal points.
4. Also open any non-return valves fitted in
the suction line.
– When the pump is switched off, re-
sidual water in the hose may flow
back and out of the pump intake.

REMEDY OF FAULTS

The following warning information applies to all work. Exceptions are marked with .
W A R N I N G
Dangerous electrical voltage!
Death or severe injury from electrocution.
Prior to starting work:
Switch off the unit, disconnect the power plug and secure the unit from being

switched on again.
 Before stepping into or reaching into the water, switch off all units located in the wa-
ter.
On completion of the work:
 Restore all the prerequisites for start-up.
Malfunction
Pump does not start.
Pump switches off after a
short running period.
12
If the pump is to be completely removed:
 D
5. Remove the connected hoses on the
pressure and suction side.
6. Undo the water drain screw and tip the
pump to allow the residual water to drain
out.
7. Screw in the water drain screw again.
– Check that the seal is in place and
correctly functioning.
Cause
The pump is switched off.
Power supply interrupted
The fault current protection
device has tripped.
Overload protection has
switched the pump off due
to overheating.
Blockage on the suction
side
ProMax Garden Classic 3000/4500
Remedy
Switch on the pump.
Check the electrical plug
connections.
Switch off the pump and
disconnect the power plug.
Then contact the OASE
Service.
 Clean the connection on
the suction side and the
suction line.
Allow the pump to cool

down.
 Clean the intake and
suction line.