Herunterladen Inhalt Inhalt Diese Seite drucken

Installation And Connection; Operation - Oase ProMax Garden Classic 3000 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für ProMax Garden Classic 3000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

INSTALLATION AND CONNECTION

N O T E
For permanent installation of the pump,
use flexible compression-proof hoses to
connect it to the pipe network to reduce
the noise of the pump.
Install the pump in a horizontal and sta-
ble position in a dry place.
– For permanent installation of the
pump, ensure that a sufficiently large
collecting basin can be positioned
underneath the discharge screw for
emptying the pump.
If possible, install the pump in a higher
position than the container/reservoir
from which the water is to be pumped. If
this is not possible, a pressure-proof
valve must be fitted between the pump
and the suction hose.
Only use vacuum-proof pressure hoses
on the pressure and suction side.
N O T E
OASE recommends:
Equip the suction line with a pre-filter
and non-return valve or foot valve.
Additionally fasten the suction hose
(e.g. by tying it to a wooden stake) to
relieve the weight of the hose on the
pump.
 B
Screw a suction and pressure hose with
25.0 mm internal diameter (1") onto the
connections.

OPERATION

W A R N I N G
Risk of injury due to hot water!
Burns to parts of the body.
Water remaining in the pump may be
heated to a high temperature in the
event of defective electronics or lack of
water supply on the suction side.
Isolate the unit (disconnect from the
power supply) before carrying out any
work on it.
Disconnect the pump from the mains at
the main circuit breaker or pull the
power plug, and allow the water to cool
down.
Start-up of the device
It is necessary to fill the pump and expel
the air from the suction line before using it
for the first time. It can take up to 10
minutes to expel air from the suction line.
How to proceed:
 C
1. Unscrew the water infill screw.
2. Pour water into the infill opening until it
overflows.
3. Screw in the water infill screw again.
4. Open the pressure line if necessary.
5. Insert the power plug into the socket.
6. Switch on the pump.
– The pump starts pumping immedi-
ately. The emerging water still con-
tains some air.
DE
EN
FR
NL
ES
PT
IT
DA
NO
SV
FI
HU
PL
CS
SK
SL
HR
RO
BG
UK
RU
CN
11

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Promax garden classic 4500

Inhaltsverzeichnis