Twist Ice Maker; How To Make Ice Cubes - Whirlpool WBA43983 Gebrauchsanweisung

TWIST ICE MAKER

HOW TO MAKE ICE CUBES

You can remove the complete Twist Ice Maker
(press and hold (1) the leveler on the left and push
it (2) towards you) or you can just remove the ice
cube tray by pulling it (3) towards you.
or
Fill the tray with potable water (maximum level =
2/3 of the overall capacity).
or
Place again the Twist Ice Maker in its seat, or
reinsert the ice cube tray within the Twist Ice
Maker. Take care not to spill water.
Wait until the ice cubes are formed (it is
recommended to wait for about 4 hours, with the
Fast Freeze option active).
NOTE: Twist Ice Maker is removable. It can be
placed in horizontal position anywhere in the
freezer compartment or taken out of the appliance
when ice-making is not required.
HOW TO TAKE ICE CUBES
1. Make sure that the storage bin is in place under
the ice tray. If not, slide into place.
2. Twist one of levers firmly in the clockwise
direction until the tray twists slightly. The ice
cubes fall into the storage bin.
3. Repeat Step 2 for the other half of the tray, if
necessary. You can make ice cubes (see the
chapter "HOW TO MAKE ICE CUBES") and
store them in the storage bin and pull it towards
you.
4. To get ice, slightly lift up the storage bin and pull
it towards you.
NOTE: if you prefer, you can remove the entire
Twist Ice Maker from the appliance, to take the ice
cubes wherever is convenient for you (for example:
directly on the table).
26
or