Cleaning - Heiniger Xpert 2-Speed/A Betriebsanleitung

Oil the blades prior to, during and after every use.
X X
Oil the blades no later than when the blades leave streaks or slow down.
X X
Apply several drops of oil on the front and on the sides of the clipping
X X
blades (see Fig. 11).
Wipe excess oil off with a soft, dry cloth.
X X
Lubrication sprays do not have sufficient oil for a good lubrication, but
X X
serve for cooling the blades.
Immediately replace damaged or notched blades in order to avoid inju-
X X
ries.
6.7

Cleaning

CAUTION!
IMPROPER CLEANING.
RISK OF DAMAGING THE CLIPPER!
Clean the clipper only with a dry cloth and with the brush sup-
X X
plied. To clean the air filter, use exclusively a dry brush or a
nailbrush.
Never use compressed air for cleaning the clipper.
X X
Housing of the clipper
Clean the housing of the clipper with a dry cloth.
X X
Shearing blade and shearing head
Use the brush supplied to clean the shearing blade and the shearing
X X
head.
Lubricate the clipping blades as described in chapter 6.6.
X X
Air filter
Fig. 12
CAUTION!
POSSIBLE DAMAGE TO THE CLIPPER!
Operating the clipper without the air filter can damage the clipper.
Only use the clipper with a properly fitted air filter.
X X
Instruction Manual / Xpert 2-Speed sheep clipper
Remove the air filter from the clipper.
X X
Clean the air filter with a dry brush
X X
or a nailbrush. Make sure no foreign
objects get into the device while
cleaning it.
Slide the air filter back onto the clip-
X X
per.
15