Dangers That Can Be Caused By The Device; Danger From Electrical Current - Heiniger Xpert 2-Speed/A Betriebsanleitung

1.3

Dangers that can be caused by the device

1.3.1

Danger from electrical current

DANGER!
DANGER OF FATAL ELECTRIC SHOCK!
Fatal electric shocks can result from contact with electrically live
conductors or components!
Always disconnect the charger power cord from the mains by
X X
grasping the plug, not the cord.
Before every use, check the clipper for externally visible dam-
X X
age. If the clipper is damaged, do not use it.
Only ever insert the charger's electrical plug into an undam-
X X
aged socket.
Never wrap the power cable around the clipper, and keep the
X X
clipper away from hot surfaces and objects.
Only permit repairs to the clipper to be made by authorised
X X
dealers or the factory customer service department; this ap-
plies especially to the replacement of a damaged power cord.
Before plugging the clipper in, compare the electrical connec-
X X
tion data (voltage and frequency) on the nameplate with that
of your electric mains. These data must be identical so that no
damage occurs to the device. If in doubt, ask your specialised
electrical dealer.
Do not under any circumstances open the housing of the clipper.
X X
If voltage-bearing connectors are disturbed or the electrical
and mechanical construction is modified, there is risk of elec-
tric shock.
Keep moisture away from the clippers. This can cause a short
X X
circuit. If you suspect that moisture has penetrated the device,
do not switch it on again; instead take it to a repair shop.
Never clip wet animals.
X X
Clean the clipper only when it is dry, using a brush or the en-
X X
closed cleaning brush.
Never submerge the clipper in water or other liquids.
X X
Always switch the clipper off before working on it. Pull the plug
X X
from the socket to prevent the device from being switched on
inadvertently.
4
Instruction Manual / Xpert 2-Speed sheep clipper