Operation; Requirements At The Place Of Use; Adjusting The Clipping Pressure - Heiniger Xpert 2-Speed/A Betriebsanleitung

When storing longer than 3 months, check periodically the general con-
X X
dition of all parts.
When not using the clipper, store it in the case making sure it is well
X X
cleaned, lubricated and that the clipping elements are not spring loaded
(risk of corrosion).
6

Operation

6.1

Requirements at the place of use

Observe the manual (see chapter 3 Technical data).
X X
Power outlets in the outer area must be equipped with a residual current
X X
circuit breaker (FI).
The work place must have adequate lighting.
X X
The electrical socket must be easily accessible so that the device can be
X X
quickly disconnected from the mains.
The charger power cord must not be taut or kinked.
X X
Make sure there is adequate ventilation.
X X
6.2

Adjusting the clipping pressure

Set the clipping pressure as follows before you start clipping:
Fig. 3
Instruction Manual / Xpert 2-Speed sheep clipper
Before beginning shearing when
X X
the machine is switched off, check
to make sure that the tapered pins
of the chicken feet exactly engage
in the positioning holes of the upper
blade.
Turn the adjusting knob in the direc-
X X
tion of the arrow until you feel resis-
tance.
Turn the knob another 1/4 turn in the
X X
direction of the arrow.
If the clipping quality deteriorates,
X X
increase the clipping pressure by
turning the adjusting knob another
1/4 turn in the direction of the arrow.
If this does not produce the desired
result, the blades must be replaced
or sharpened.
11