Hartan RS one S Bedienungsanleitung Seite 17

Instructions for use
Sun canopy — Silently adjustable hood
Press the two front hood bows together 9 to adjust the hood. By taking off
the rear hood section 10, the hood can be converted into a sun canopy
by means of a zip fastener. As an additional protection, the sun visor 20 can
be pulled out.
Lock-type-swivel wheels
Turn the cap 21 so that the red point faces forward to pre-select the straight-
line motion mode, which will be activated the moment the wheels point in
forward direction. Turn the cap 21 so that the green point faces in forward
direction to release the swivel lock. There is a push-button inside the cap 21.
To remove the wheel, depress this button and pull the wheel off the holding
device. To assemble the wheel, insert the fastening pin in the holding device,
and engage it by a forcible push, which is indicated by a click sound.
Adjustable suspension system
By turning the selector 8, a "hard" or "soft" position can be selected for
suspension.
Automatic lock for upper section
Place the stroller unit upon the chassis and pull it into the upper-section lock
slots on each side 17 until the catching pins on both sides have engaged,
which is indicated each time by a click sound.
WARNING! By pulling the upper section horizontally, check before use
whether it is fixed correctly! When removing the upper-section, the lock will
close automatically. To release the upper-section lock, push the locking cap
(see the arrow) back and press the red securing button downwards until it has
engaged. WARNING! When the locking cap is in pushed back position and
the red safety point can still be seen, the upper-section lock has not yet clo-
sed completely.
Adjusting the footrest
First, press the two buttons 15, located at the right and left side respectively,
to fold the footrest down. Then raise the footrest to the required position.
A number of settings up to the horizontal position can be selected. To prolong
the footrest, press the two buttons 16, and pull it out. WARNING! In case the
carrycot is attached to the frame, the footrest should always be in horizontal
position, as an additional protection preventing it from slipping out.
Adjusting the backrest
By lifting the back clip 13 at the rear, the backrest can be adjusted from sitting
to reclining position in close steps. WARNING! When adjusting the backrest,
take care that no movable parts jam the baby's limbs, or fingers, etc. Finally,
make sure the backrest has reengaged properly.
13