Philips HQ6740 Handbuch Seite 2

ENGLISH
4
C
C
Important
Read these instructions for use carefully before
using the appliance and save them for future
reference.
Only use the HQ600 powerplug and the
charging stand supplied to charge the shaver.
The powerplug is suitable for mains voltages
ranging from 100 to 240 volts.
The powerplug contains a transformer. Do
not cut off the powerplug to replace it with
another plug, as this will cause a hazardous
situation.
The powerplug transforms 100-240 volts to
12 volts.
Make sure the HQ600 powerplug and the
charging stand do not get wet.
The shaver runs at a safe low voltage of 12
volts. It is watertight and can be cleaned
under the tap. Do not rinse the shaver with
water hotter than 80cC.
For the best shaving results, shaving emulsion
should be pumped up frequently.
If the mains cord of this appliance is damaged,
it must always be replaced by Philips or a
service centre authorised by Philips in order
to avoid hazardous situations.
Charge indications
When the batteries are almost empty, the red
pilot light blinks a few times after the shaver
has been switched off.