Standards And Approvals - Epson TM-P60II Benutzerhandbuch

For American Users
WARNING:
The cords included with this product contain chemicals, including lead,
known to the State of California to cause birth defects or other
reproductive harm. Wash hands after handling. (This notice is provided in
accordance with Proposition 65 in Cal. Health & Safety Code §25249.5 and
following.

Standards and Approvals

The following standards are applied only to the printers that are so labeled. (EMC is tested using EPSON
power supplies.)
Europe: CE Marking
®
For Wi-Fi models (Model: M292C)
Directive: 1999/5/EC
EN 300 328
EN 301 893
EN 50566
EN 301 489-1
EN 301 489-17
EN 60950-1
EN 62311
North America: FCC Class B, ICES-003 Class B
Oceania: RCM Marking
For Wi-Fi models (Model: M292C)
AS/NZS CISPR 22 Class B
AS/NZS 4268
EN 62209-2
We, Seiko Epson Corporation, hereby declare that the equipment Models, M292C and M292D, are in
compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
The connection of a non-shielded printer interface cable to this printer will invalidate the EMC standards
of this device.
You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation
could void your authority to operate the equipment.
FCC Compliance Statement For American Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
6
®
For Bluetooth models (Model: M292D)
Directive: 1999/5/EC
EN 300 328
EN 301 489-1
EN 301 489-17
EN 60950-1
EN 62311
For Bluetooth models (Model: M292D)
AS/NZS CISPR 22 Class B
AS/NZS 4268
WARNING