Changing The Tool; Starting Operation - Bosch PushDrive Originalbetriebsanleitung

26 | English
Do not continue to apply pressure to the spindle after the power tool has auto-
u
matically switched itself off. This can damage the battery.
Open the cover (7).
Use a USB cable (9) to connect the power tool to the charger (10).
The battery charge indicator (4) indicates the charging progress. The indicator flashes
green during the charging process. When the battery is fully charged, the indicator is lit
up green continuously.
During the charging process, the handle of the power tool will heat up. This is normal.
If you are not planning to use the power tool again soon, disconnect it from the power
supply.
The power tool cannot be used during the charging process. It is not defective if it does
not work during the charging process.
Follow the instructions on correct disposal.

Changing the tool

Do not use two-sided screwdriver blades that are longer than 25 mm.
u
Slide the rotational direction switch (3) into the middle position. This locks the spindle in
place, preventing the drive from starting up when the tool bit is changed.
Insert the screwdriver bit (1) directly into the tool holder (2).
Operation

Starting Operation

Setting the rotational direction (see figure A)
Do not use the rotational direction switch (3) when the power tool is in opera-
u
tion, as this may damage it.
Clockwise rotation: To drive in screws, slide the rotational direction switch (3) for-
wards.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational direction
switch (3) backwards.
Locking the spindle (see figure B)
To lock the spindle in place, slide the rotational direction switch (3) into the middle posi-
tion.
This allows screws to be driven in even when the battery is discharged and enables the
power tool to be used as a screwdriver.
1 609 92A 4TP | (27.11.2018) Bosch Power Tools