Changing The Tool - Bosch PushDrive Originalbetriebsanleitung

24 | English
Fitting
Before any work on the tool (e.g. maintenance, tool change, etc.) as well as dur-
u
ing transport and storage, set the rotational direction switch to the middle posi-
tion. There is a risk of injury from unintentionally starting the tool by applying pres-
sure to the spindle.
Charging the battery (see figure C)
Do not use any other charger. The supplied charger is matched to the lithium-ion
u
battery that is fitted in your power tool.
Note: The battery is supplied partially charged. To ensure full battery capacity, fully
charge the battery in the charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its service life. Inter-
rupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the "Electronic Cell Pro-
tection (ECP)". When the battery is discharged, the power tool is switched off by means
of a protective circuit: The application tool no longer rotates.
Do not continue to apply pressure to the spindle after the power tool has auto-
u
matically switched itself off. This can damage the battery.
Open the cover (7).
Use a USB cable (9) to connect the power tool to the charger (10).
The battery charge indicator (4) indicates the charging progress. The indicator flashes
green during the charging process. When the battery is fully charged, the indicator is lit
up green continuously.
During the charging process, the handle of the power tool will heat up. This is normal.
If you are not planning to use the power tool again soon, disconnect it from the power
supply.
The power tool cannot be used during the charging process. It is not defective if it does
not work during the charging process.
Follow the instructions on correct disposal.

Changing the tool

Do not use two-sided screwdriver blades that are longer than 25 mm.
u
Slide the rotational direction switch (3) into the middle position. This locks the spindle in
place, preventing the drive from starting up when the tool bit is changed.
Insert the screwdriver bit (1) directly into the tool holder (2).
1 609 92A 48W | (07.05.2018) Bosch Power Tools