Feig Electronic OBID ID ISC.LRU2000 Montageanleitung Seite 53

®
OBID i-scan
4.1.1.1 Address assignment of RS485/RS422 for bus operation
For bus operation the Reader can be assigned the required bus address via software.
The address is assigned by the host computer. The software is used to assign addresses "0"
through "254" to the Reader.
Note:
Since all Readers are factory set with address „0", they must be connected and configured
one after the other.
4.1.2 Network connection - LAN
The prerequisite for using TCP/IP protocol is that each device has a unique address on the
network. All Readers have a factory set IP address.
The Readers must be connected and configured one after the other.
Table 4-4: shows the standard configuration of the network connection.
FEIG ELECTRONIC GmbH
Network
IP address 192.168.10.10
Subnet mask 255.255.255.0
Port 10001
Table 4-4: Standard configuration of the network connection
Installation
Address
Page 53 of 56
ID ISC.LRU2000
M60801-0de-ID-B.doc