External Diagnostic Led Connections - Feig Electronic OBID ID ISC.LRU2000 Montageanleitung

®
OBID i-scan

2.8 External diagnostic LED connections

X14 allows for connection of additional external LEDs in parallel with the internal diagnostic LEDs.
The external LEDs are connected as shown in Fig. 2-9.
Terminal
1
2
3
4
5
6
Table 2-10: External LED pin-outs
Note:
• The outputs on X14 are intended for switching an external LED only. Overloading the
outputs with other loads may destroy them.
FEIG ELECTRONIC GmbH
Installation
Abbreviation
V1 Function same as internal LED V1
Anode ext.
V2 Function same as internal LED V2
Anode ext.
V3 Function same as internal LED V3
Anode ext.
V4 Function same as internal LED V4
Anode ext.
V5 Function same as internal LED V5
Anode ext.
GND Common GND
V5
V6
S1
X14
X14
X14
2 4 6
1 3 5
Fig. 2-9: Connecting external LEDs to X14
Page 45 of 56
Description
ACC-Modul
T1
1
2
3
4
5
V5 V4 V3 V2
6
external LEDs
ID ISC.LRU2000
V1
M60801-0de-ID-B.doc