Emptying And Cleaning The Machine After Use English 9; Maintenance; Disturbances / Fault Finding; English - Cleanfix Ra 300 E Bedienungsanleitung

5. Emptying and cleaning the machine after use
Rinse the waste water tank with clean water.
☞
When replacing the membrane tank make sure the tank fits
properly into the waste water tank.
The tab of the membrane tank must be fitted on the left
☞
side of the clean water tank opening (seen from behind
the machine).
A
B
7.

Disturbances / Fault finding

Disconnect electrical cable before working on the unit!
Only do repairs and service that are mentioned in these operating instructions.
Leave service and repairs, especially repairs on electrical components, the after sales service of an authorised service agent.
The following advise will help you detect disturbances and help you resolve them:
Disturbance
Machine does not work
Insufficient vacuuming power
Unclean vacuuming by squeegee
Not enough water flow or no water
coming to the brushes
Should the vacuum cleaner not work after checking above faults, please contact authorised service agent!

English 8

RA 300 E - English
☞ Once the edge of the mem-
brane tank comes over the rim
of the tank opening push the
entire membrane into the tank
and remove the membrane
tank through the large opening
of the waste water tank . Em-
pty the membrane tank and
rinse with clean water.
☞ Hang up the membrane
tank for drying.
☞ Remove the vacuuming hose
and the clean water hose from
the tank cover and rinse the tank
cover thoroughly. Make sure that
the filtre (A) of the clean water
suction hose (B) is cleaned too.
☞ Clean the machine and the
squeegee with a damp cloth.
Reason
☞ Electrical supply interrupted
☞ Fuse blown
☞ Electrical supply interrupted
☞ Suction nozzle plugged
☞ Squeegee blocked
☞ Tank cover not properly fitted or
seal defective
☞ Connection of cover open
☞ Filter in tank covered blocked
☞ Cover of waste water discharge not
well placed.
☞ Rubber blades on squeegee dirty or
worn-out
☞ Water tubes blocked
Rinse brushes or pads with clean water. To clean the
☞
brushes and pads tilt the unit to the back and remove
the brushes or pads by slightly pulling them
downwards. When replacing make sure they rest into
the groves.
6.

Maintenance

If you maintain the machine carefully the unit will stay in
working order for a long period of time. Regularly inspect
the machine for wear and tear.
Regularly inspect the rubbel Blattes of the squeegee.
The machine should not be cleaned with a prssure
washer ore steam cleaner.
For repairs and service only original parts may be
used.
Before repairing the machine disconnect electrical
cable!
Removal
Plug-in connection.
●
Check fuse.
●
Check and replace fuses or the
●
motor protection swithes.
Eliminate plugging.
●
Removed dirt from squeegee.
●
Place tank cover correctly or
●
replace seal.
Connect hose
●
Clean filtre with water.
●
Check cover and place it
●
properly.
Clean or remove rubber blades.
●
Remove entire squeegee by
pushing the two levers on the body
of the squeegee.
Rinse clean water tank and tubes
●
leeding to the brushes.
Clean vacuuming filtre in the tank.
●
10