AXTON C208 Bedienungsanleitung Seite 28

Make sure you are using a main fuse protection for the +12V-
5
power input of the amplifier within max. 30 cm of the car bat-
tery and power cables with an amperage adequate cross-section and
main fuse (for details see section E: „Connecting").
The GROUND/GND cable (-12V) should have the same cross-
6
section as the +12V power cable. Make sure to get a good chas-
sis ground contact, because poor ground contacts are the cause for
most power problems with car audio installations.
Make sure no power, signal or speaker lines are shorting to
7
chassis ground by using rubber grommets wherever a cable
has to pass through any metal part of the vehicle.
Important: Before any wiring, always remove the +12V terminal
of the battery to prevent short-circuiting. The last lead to be connec-
ted in every installation is always the positive +12 Volt terminal
of the battery. Connect this lead only after having completed and
checked all other connections.
28