Dust Protection Frontal Shield; Maintenance; Sunshield Removal; Opening And Closing The Housing - Videotec NVX Bedienungsanleitung

11.7 Dust protection frontal
shield
Fig. 36

12 Maintenance

Before doing any technical work on the
device, disconnect the power supply.
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.

12.1 Sunshield removal

The product is supplied with the sunshield already
installed.
For installation or maintenance needs, the sunshield
can be dismantled. Unscrew the sunshield screws and
remove it.
Re-assemble the sunshield before fastening the
housing to the housing support.
Pay attention to the fixing. Tightening
torque: 4Nm (±0.5Nm).
Fig. 37
22
12.2 Opening and closing the
housing
To carry out some maintenance operations, the
housing must be opened.
Carefully remove the front slide. Pay
attention not to damage the internal
connection cables.
Unscrew the closure screws and remove the slide
connected to the front of the housing.
Fig. 38
To close the housing, follow the inverse procedure.
Pay attention to the fixing. Tightening
torque: 4.5Nm (±0.5Nm).
MNVCNVX_1903_EN