Makita DBM 080 Originalbetriebsanleitung Seite 7

ENGLISH
Technical Characteristics:
Rated voltage:
Rated power input:
Load speed:
Drilling capacity up to:
Protection class:
Collet:
Collar clamping diameter:
Weight according to EPTA Procedure 01/2003:
Diamond drill motors are designed for professionals and should only be used by authorized persons.
All rights of changes due to technical development reserved.
Symbols
The following symbols are used for the equipment. It is important to know their meaning before you
use the tool.
Intended use
The Makita Diamond Dry Core Drill DBM 080 / DBM 130 is designed for the drilling of brick, lime sand
brick, cellular concrete, and others in combination with a Diamond Dry Drilling System with dust
aspiration (use an appropriate Wet Core Drill for concrete and stone).
The user is liable for any damages due to a not intended use of the device.
Generally accepted accident prevention regulations and included safety guidelines have to be
observed.
Power supply
Before starting the machine, compare the supply voltage and frequency with the data stated on the
type plate. A voltage difference of +6% / -10% is permitted.
Do only use an extension cable with sufficient cross section (at least 2.5 mm
too small may lead to excessive loss of power and overheating of the motor and the cable.
Work with concentration and care.
Keep your workplace clean and avoid hazardous situations.
Precautions shall be taken to protect operators.
Double protective insulation
DBM 080
110 V~ / 230 V ~
1300 W
0- 2000 rpm
82 mm
II
M 18
46 mm
3,4 kg
Read instructions
DBM 130
110 V~ / 230 V ~
1500 W
0-1000 rpm
0-2000 rpm
132 mm
70 mm
II
M 18
53 mm
5,5 kg
2
). A cross section that is