Sony DR-GA500 Bedienungsanleitung Seite 19

To adjust the volume level from the sound device
(GAIN CONTROL)
The GAIN CONTROL adjusts the volume according to the rated output of the sound device
(initial setting is "8"). Increase the GAIN CONTROL more than "8" if the output is low, even
when the volume of the sound device is maximized. And if sound is distorted, decrease the
volume level of the output on the sound device.
Rear panel of the processor
Sound device
rated output
More than 2Vrms
2Vrms
Less than 2Vrms
To set the system to enter the standby mode automatically
(AUTO STANDBY function)
The processor enters the standby mode automatically if the processor does not input sound for
about 30 minutes.
You can turn the AUTO STANDBY function ON/OFF by the AUTO STANDBY switch.
Rear panel of the processor
Position of switch
ON
OFF
GAIN CONTROL level
Adjust the GAIN CONTROL level to "8, " and then adjust the audio output device
to lower the sound.
This processor is calibrated for 2Vrms standard output to the sound device when
the GAIN CONTROL is set to "8. "
"8" - "10, " the GAIN CONTROL level adjust for the louder volume.
Effect
The AUTO STANDBY function will work. Turn on the system again by pressing
the  /  (on / standby) switch.
The AUTO STANDBY function will not work.
Rotate left to Rotate right
decrease the to increase
level the level
OFF ON
AUTO STANDBY
Operation
19
GB