Menü Cs 13Xx (Iso 4406:1987 Und Nas) - HYDAC International CS1000 Serie Betriebs- Und Wartungsanleitung

ContaminationSensor CS1000
Analog output (ANaOUT)
Restart measurement, discard changes (CANCEL)
Restart measurement, save changes (SAVE)
Menü CS 13xx (ISO 4406:1987 und NAS)
Power Up Menu
Measuring mode (MODE)
Measuring time (mTIME)
Pump protection (pPRTCT)
Bus address (ADRESS)
Factory defaults (DFAULT)
Calibration selection (CALIB)
Cancel (CANCEL)
Save changes, leave Power Up Menu (SAVE)
For internal use (CODE)
Measuring Menu
Display (DSPLAY)
HYDAC Filtertechnik GmbH
BeWa CS1000 3247149n de 2009-02-04.doc
Mode „1" (M1)
Mode „2" (M2)
Mode „3" (M3)
Mode „4" (M4)
Mode „Single" (SINGLE)
Set value (60)
Set value (0)
HECOM3b address (HECOM)
(IP) reserved for future use
(MODBUS) reserved for future use
ISO99/SAE (ISoSAE)
ISO87/NAS (ISoNAS)
ISO-Code (ISO)
NAS-class 2 (NAS 2)
NAS-class 5 (NAS 5)
NAS-class 15 (NAS 15)
NAS-class 25 (NAS 25)
NAS Maximum (NAsMAX)
Flow rate (FLOW)
Analog output (ANaOUT)
Measuring cell LED current (DRIVE)
Temperature (TEMP C)
Temperature (TEMP F)
de
Überblick Menüstruktur
SAE A-D (SAeMAX)
SAE class A/B/C/D (SAE)
SAE class A/B/C/D + Temperature (SAE+T)
Temperature (TEMP)
HDA+ISO (HDaISO)
HDA+SAE (HDaSAE)
ISO-class 4µm (ISO 4)
ISO-class 6µm (ISO 6)
ISO-class 14µm (ISO 14)
ISO Code (ISO)
ISO Code + Temperature (ISO+T)
SAE A (SAE A)
SAE B (SAE B)
SAE C (SAE C)
SAE D (SAE D)
Set value (A)
Seite 43 / 100
2009-02-04