Überblick Menüstruktur; Menü Cs 12Xx (Iso 4406:1999 Und Sae) - HYDAC International CS1000 Serie Betriebs- Und Wartungsanleitung

ContaminationSensor CS1000
Überblick Menüstruktur
Menü CS 12xx (ISO 4406:1999 und SAE)
Power Up Menu
Measuring mode (MODE)
Measuring time (mTIME)
Pump protection (pPRTCT)
Bus address (ADRESS)
Factory defaults (DFAULT)
Cancel (CANCEL)
Save changes, leave Power Up Menu (SAVE)
For internal use (CODE)
Measuring Menu
Display (DSPLAY)
Switching output (SWtOUT)
HYDAC Filtertechnik GmbH
BeWa CS1000 3247149n de 2009-02-04.doc
Mode „1" (M1)
Mode „2" (M2)
Mode „3" (M3)
Mode „4" (M4)
Mode „Single" (SINGLE)
Set value (60)
Set value (0)
HECOM3b address (HECOM)
(IP) reserved for future use
(MODBUS) reserved for future use
ISO-Code (ISO)
SAE-class A (SAE A)
SAE-class B (SAE B)
SAE-class C (SAE C)
SAE-class D (SAE D)
SAE A-D (SAeMAX)
Flow rate (FLOW)
Analog output (ANaOUT)
Measuring cell LED current (DRIVE)
Temperature (TEMP C)
Temperature (TEMP F)
Mode „1" (M1)
No settings necessary (NO SET)
Mode „2" (M2)
Switching point (SP1)
Mode „3" (M3)
Measuring Channel (MEAsCH)
Target cleanliness (TARGET)
Mode „4" (M4)
Measuring Channel (MEAsCH)
Target cleanliness (TARGET)
Upper limit (RSTART)
Test cycle time (CYCLE)
Mode „Single" (SINGLE)
de
Überblick Menüstruktur
Set value (A)
Measuring channel (MEAsCH)
SAE A-D (SAeMAX)
SAE class A/B/C/D (SAE)
ISO-class 4µm (ISO 4)
ISO-class 6µm (ISO 6)
ISO-class 14µm (ISO 14)
ISO Code (ISO)
Temperature (TEMP)
SAE-class A (SAE A)
SAE-class B (SAE B)
SAE-class C (SAE C)
SAE-class D (SAE D)
Switching function (SwFNCT)
Beyond limit (BEYOND)
Below limit (BELOW)
Within band (WITHIN)
Outside band (OUTSDE)
No switch (OFF)
Limits (LIMITS)
Lower limit (LOWER)
Upper limit (UPPER)
ISO (ISO)
SAE (SAE)
ISO (ISO)
SAE (SAE)
Set value (60)
Seite 42 / 100
2009-02-04