Maintenance; Installing & Cleaning Cartridge Filter - Vacmaster VWM1218R Gebrauchsanweisung

5. Fit the desired extension wand and or nozzle to the free end of the vacuum hose. (fig. 4)
6. Ensure the power switch is turned off and plug in the power supply. (fig. 5)
7. Before turning ON the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch to
the 'I' ON position or use the vac with switch set to remote control setting and the remote control. (fig. 6)
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Disconnect the hose from the vacuum. (fig. 2)
3. Remove the vacuum from the mounting rack.
4. Undo the latches and remove the power head from the container. (fig. 3)
5. Clear all dirt or debris from the container and hose. (fig. 4)
6. Clean the foam filter by washing it with water and mild soap. (fig. 5)
7. Check the hose, attachments, and power cord to verify that they have not been damaged.
IMPORTANT!
Clean or change the cartridge filter regularly for best performance. ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used with out the cartridge filter, the
motor will burn out and the warranty will be voided. Always keep spare filters on-hand.
NOTICE!
The filters included are made of high quality materials designed to stop small dust particles. The
cartridge filter should be used for dry pick-up and small amounts of liquids. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet, it will clog quickly and be difficult to clean. Handle the filter
carefully when removing it for cleaning and replacing it. Check the filters for tears or small holes, a small
hole can let dust pass through and out of the cleaner. Do not use a filter with holes or tears in it, replace it
immediately.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE CONTAINER.
INSTALLING & CLEANING CARTRIDGE FILTER
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet.
2. Remove power head and place in upside down position.
3. Install the cartridge filter over the filter cage with the flat end of the filter towards the vacuum power head.
Carefully push filter in until it stops against the power head. (fig. 1 & 2)
4. Place filter retainer on top of cartridge filter over the raise lip and tighten down by turning retainer handle

MAINTENANCE

11
GB