Scope Of Supply; Device Description; Prior To Use; Safety Devices - Mafell S 200 Originalbetriebsanleitung

2.4 Scope of supply

Dust extractor S 200 complete with:
Container Art.-No. 206869,
incl. 2 shavings bags 200l,
-
1 catch,
-
1 kink protection,
-
1 operating manual
-
S 35 M

2.5 Device description

The high volume dust extractor S 200 is only intended
to be used as dry extractor.
It is delivered together with a complete dust extractor
S 35 M.
Alternatively also available without S 35 M (container
Art.-No. 206869)
All the information concerning the S 35 M can be
referenced from the operating instructions enclosed
with the dust extractor (Art.-Nr. 170425 or 170426).
2.5.1

Prior to use

- Pay attention to completeness and transport
damages when unpacking the device.
- Prior to use, the users should be supplied with
information, instructions and training regarding the
use of the dust extractor and the substances for
which it is to be used, including the safe method to
dispose of the extracted material.
Diligently read these operating instructions and those
of the S 35 M before starting up the dust extractor.
They provide important information on operation,
safety, maintenance and care. Keep the operating
instructions in a safe place and pass them on to the
next owner when selling the device.

2.6 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The high volume dust extractor S 200 is suitable for
increased loads in case of commercial use.

2.7 Use according to intended purpose

Danger
In general, it is not permitted to
vacuum any combustible or
explosive solvents, liquids such as
petrol, oil, alcohol, thinners or
materials with a temperature in
excess of 60 °C. Otherwise there
will be danger of explosion and fire!
The high volume dust extractor can be used to extract
insulation fibres and wood shavings from wood
working machines. The extraction fitting diameter is Ø
35 mm.
The high volume dust extractor is suitable for
vacuuming / extracting wood shavings and insulation
fibres.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
The dust extractor S 200 may only be used, set up
and serviced by persons who are acquainted with the
device and have been instructed about the hazards
involved. Corrective maintenance work must be
carried out by MAFELL authorised dealers or
MAFELL customer service stations.
The safety instructions applicable in the respective
country of use as well as other generally recognised
rules pertaining to safety and occupational health
must be observed.
-13-