Master F-12 Bedienungsanleitung Seite 70

6.2 Getting Started
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch located at
the front of the treadmill below the motor shield. Ensure that the safety key is installed, as the treadmill will not
power on without it. When the power is turned on, all the lights on the display will light for a short time.
Self-Checking
When using for the first time, it is necessary to make the machine carry on self-check:
•
Remove the safety key, press MODE and hold, then insert the safety key again, the machine enters
into self-checking state. During this state, pressing START/STOP can terminate the self-checking.
6.3 Quick-Start Operation
1. Press and release the START/STOP to wake display up (if not already on). Note: Installing the
safety key will also wake up the console.
2. Press and release the START/STOP to begin belt movement, at 1.0 Km/hr, then adjust to the
desired speed using the '+' or '-'. You may also use the rapid speed keys (2,4,6...12) to adjust
the speed. The speed range is from 1.0km/h to 12.0km/h. You can also use '+' or '-'to adjust the
speed on handrail.
3. To slow the treadmill down, press and hold the '-' key to desired speed. You may also press the
rapid speed adjust keys: 2,4,6...12.
4. In a state of running, single press START/STOP, the walking belt will gradually slow down if the
speed is above 3.5km/h, if under 3.5km/h, then it will stop immediately.
5. In the state of running, single press CLEAR will reset all number except the speed. Then enter
into manual mode.
6. To stop the tread-belt press and release the START/STOP.
6.4 Incline Feature
When use the treadmill,you can select the different incline according your own fitness program.
1
2
70
EN