Preparation For Use; Setup - Pari BOY SX Gebrauchsanweisung

3 PREPARATION FOR USE

3.1 Setup

The room in which the compressor is operated must satisfy
The room in which ...
certain conditions [See also: 6.5 Ambient conditions for opera-
tion]. The compressor is not intended for outdoor use.
When setting up the compressor, ...
CAUTION
When setting up the compressor, follow the instructions below to
avoid any risk of injury or damage to the device:
– Place the compressor on a firm, flat, dust-free, dry surface.
A soft base such as a sofa, a bed or tablecloth is not suitable
because the compressor might fall.
– Route the power cord in such a way that it is not a tripping
hazard and no one can become entangled in it.
– Make sure that children cannot pull on the power cord or
connection tubing and cause the compressor to fall.
– Only operate the compressor in a low-dust environment. If it is
operated in a very dusty environment (e.g., under the bed or
in workshops), or on the floor, a larger amount of dust is likely
to collect inside the housing, which may impair the quality of
the treatment or damage the compressor.
To avoid a ...
WARNING
To avoid a risk of fire due to a short circuit, follow the
instructions below when setting up the compressor:
– Do not operate the compressor close to flammable objects
such as curtains, tablecloths, or paper.
– Do not operate the compressor in areas where there is a risk
of explosion or in the presence of oxidising gases (e.g.,
oxygen, nitrous oxide, flammable anaesthetics).
- 35 -
en