Commissioning; Shutdown; Environment/Disposal; Service Work - Buderus PW 500.6-C Installations- Und Wartungsanleitung

6

Commissioning

NOTICE: Risk of system damage from excessive pressure.
▶ Observe the maximum operating pressure ( tab. 3,
page 36).
Commissioning must be performed by an authorised contractor.
▶ Check the tightness of all connections ( Fig. 22, page 74).
▶ Commission all assemblies and accessories as specified in the
manufacturer's technical documents.
7

Shutdown

DANGER: Risk of scalding from hot water!
▶ Allow the buffer cylinder time to cool down sufficiently
after being shut down.
NOTICE: Cylinder damage from frost!
If there is a risk of frost when you are away from home,
we recommend the following:
▶ Leave the buffer cylinder operational.
or
▶ Take the buffer cylinder out of operation and drain it.
▶ If an immersion heater has been installed (accessory), isolate the
buffer cylinder from the power supply.
▶ Switch off the temperature controller at the control unit.
▶ Fully drain the buffer cylinder.
▶ Shut down all assemblies and accessories of the heating system as
specified in the manufacturer's technical documentation.
▶ Open the system drain valve.
▶ For ventilation, open the air vent valve. The air vent valve is located at
the top of the cylinder ( Fig. 14, [1], page 72).
▶ Close the shut-off valves.
▶ Depressurize the heat exchanger.
▶ Drain and blow out the heat exchanger.
To prevent corrosion:
▶ Leave the connector pipes open, so that the interior can dry out well.
PW/P/PR/PNR/PNRZ... – 6 720 817 509 (2017/05)
8

Environment/disposal

Environmental protection is a key commitment of the Bosch Group.
Quality of products, efficiency and environmental protection are equally
important objectives for us. All legislation pertaining to the
environmental protection is strictly observed. To protect the
environment we use the best possible technology and materials, subject
to economic considerations.
Packaging
Where packaging is concerned, we participate in country-specific
recycling systems that ensure optimum recycling. All of our packaging
materials are environmentally compatible and can be recycled.
Used appliances
Old appliances contain materials that should be recycled.
The relevant assemblies are easy to separate and all plastics are
identified. In this way the individual assemblies can be easily sorted and
directed to recycling or disposal.
9

Service work

With buffer cylinders, apart from visual checks, no particular
maintenance or cleaning work is necessary.
▶ Check all connections externally for leaks once a year.
▶ In the event of a fault, contact an approved contractor or the
customer service.
Commissioning 6
41