Closing The Door; Installation - Electrolux EUF2743AOW Benutzerinformation

30 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
Door is misaligned or inter‐
feres with ventilation grill.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

8.2 Closing the door

1. Clean the door gaskets.

9. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The appliance is in dem‐
onstration mode.
The appliance is not lev‐
elled.
The temperature regula‐
tor is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
The FastFreeze function
is switched on.
There is no cold air circu‐
lation in the appliance.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Refer to "Levelling".
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Open the door only if neces‐
sary.
Refer to "FastFreeze func‐
tion".
Make sure that there is cold
air circulation in the appli‐
ance.
to "Installation".
door gaskets. Contact the Authorised
Service Centre.