Klarstein 10032863 Handbuch Seite 20

EN
INSTALLATION
On installation, the minimum distance between the hob and the hood must be exactly
complied with (see chapter 7.1 "Installation data") and follow the numbering of the
steps and the additional instructions. Execution with air exhausted outdoors (A- see also
the installation data). The vapours are extracted via an air exhaust hose fixed to the
connector ring.
The diameter of the exhaust air hose must conform to that of the connector ring. If a
smoke non-return valve is used or is planned, check whether it can open and close
freely after the installation of the exhaust air hose. The extractor hood can be equipped
with one (top) or two (top and back) extractor openings.
The hood is normally initially fitted out for use of the top extractor opening, as an
extractor hood. Openings not required are fitted with a plastic cover. This plastic cover
can be easily removed by turning counterclockwise and optionally fitted to another
opening which is not required.
Measurements
20