Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Mounting
Application
The letterflap module BE 611-3/1-...
resp. BE 611-4/1-... is used at the
front of the BKV 611-3/... resp.
BKV 611-4/... or mounted
individually as a letter flap for doors
or door side panels. The pass-
through opening can be individually
adjusted prior to mounting. It is
possible to completely close the
pass-through opening.
Mounting
i i
1 The mounting block in the
BKV 611-3/... resp. BKV 611-4/... is
ideally prepared for integration of
the BE 611-... in flush-mounted
letterboxes. Adjustment of up to
max. 15 mm is possible to align with
the plaster. To adjust, release the
fastening screw. Place for example a
spirit level over the opening and
push the fastening block with the
two support shoulders against it.
Tighten the fastening screw again.
2 The pass-through opening of the
BE 611-3/1-... resp. BE 611-4/1-...
can be individually defined as
required.
a) Pass-through opening for the
BKV 611-... (condition on delivery)
b) Pass-through opening in accor-
dance with DIN EN 13724
c) Pass-through opening of 18 mm
for improved security against
pilfering.
d) Pass-through opening closed for
temporary periods of disuse or
absence, such as holidays.
To adjust the pass-through opening,
release the position screw at the side
of the BE 611-..., change the pass-
through opening accordingly and
replace the position screw.
3 Mounting the BE 611-3/1-... or
BE 611-4/1-...
Lay the combination frame over the
integrated letterbox housing, insert
the BE 611-... and screw on both
sides using the provided screws.
4 4
4 Mounting the combination
frame greater than KR 611-4/3-...
or KR 611-4/4-...
Short fixing brackets are provided
with the combination frame. These
are used to fix the KR 611-... in the
external corners of the BKV 611-...
These fixing brackets are only used
in conjunction with BKV 611-3/... or
BKV 611-4/...
5 Lay the KR 611-... over the letter-
box unit and fix at the fastening
block using the provided screws.
6 (no illustration)
Insert the BE 611-... in the letter-box
and fasten on both sides using the
Torx screws. (Screws and screw-
driver are provided).
7 Insert mounting frame MR 611-...
into the GU 611-... and fasten at the
corners using the enclosed quick-
closing screw. See product
information „Vario mounting
instructions".
8 (not illustrated)
For details on the insertion Siedle
Vario function module, see the
product information „Vario mount-
ing instructions".
Mounting the BE 611-3/1-...
as a door pass-through letterflap
9 Installation dimensions
10 Final mounting of the
BE 611-3/1-...
Mounting the BE 611-4/1-...
as a door pass-through letterflap
11 Installation dimensions
12 Final mounting of the
BE 611-4/1-...
Inscription
13 Inscribing the nameplate of the
BE 611-... : Release the name-plate
cover by levering using a small
screwdriver. To replace the name-
plate cover, clip into place on the
right and close by exerting a slight
pressure.
14 Inscribing the nameplate on the
letter removal door: Open the letter
removal door. Pull the top part of
the nameplate cover on the inside of
the letter removal door towards you
and hinge upwards. Close the cover
in reverse sequence.
Werbung
