Instructions For Use; Inserting/Replacing The Battery - Flex RSP DW 18.0-EC Originalbetriebsanleitung

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack the power tool and accessories and
check that no parts are missing or damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Inserting/replacing the battery

 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
18
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
The indicator goes out after 5 seconds.
NOTE
Follow the instructions for charging the
battery set out in the charger operating
manual.
Inserting/changing the saw blades
WARNING!
Remove the battery before carrying out any
work on the power tool.
Discharging used saw blade
CAUTION!
Used cutting accessories may become
–
hot. Wear protective gloves!
Ensure that no persons, animals or
–
sensitive surfaces are in the line of fire
when discharging.
 Release tool holder lock by turning anti-
clockwise and hold (1.).
Used saw blade is discharged under
spring pressure (2.).
RSP DW 18.0-EC