Special Safety Instructions; Noise And Vibration - Flex RSP DW 18.0-EC Originalbetriebsanleitung

RSP DW 18.0-EC

Special safety instructions

 Do not work on materials which release
hazardous substances (e.g. asbestos).
 Identify the power tool with stickers only.
Do not drill any holes into the housing.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The A-weighted noise level of the power tool
is typically:
– Sound pressure level:
– Sound power level:
– Uncertainty K:
Total vibration value when sawing wood:
– Emission value a
when sawing chipboard:
– Emission value a
when sawing wooden beam: 12.1 m/s
– Uncertainty K:
ATTENTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 62841 and may be used to compare one
tool with another. It may be used for a pre-
liminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary to
take into account the times when the tool is
switched off or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
88 dB(A);
99 dB(A);
3 dB.
h
9.1 m/s
h
1.5 m/s
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and
the cutting accessories, keep the hands
warm, organisation of work patterns.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
2
2
2
17