Specifications - Makita PW5000C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
1-2. Cover
2-1. Slide switch
3-1. Speed adjusting dial

SPECIFICATIONS

Rated speed (n)/No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for surface work with natural stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : stone polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
Explanation of general view
4-1. Lever
4-2. Open
4-3. Close
6-1. Abrasive disc
Model
Spindle thread
Pad diameter
)
0
Overall length
Net weight
Safety class
) : 85 dB(A)
pA
) : 96 dB(A)
WA
2
) : 5.0 m/s
h,P
2
ENE057-1
power tool is used for other applications, the
vibration emission value may be different.
ENF002-2
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
ENG905-1
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
ENG900-1
machine(s):
Designation of Machine:
Stone Polisher
Model No./ Type: PW5000C,PW5000CH
are of series production and
Conforms to the following European Directives:
2006/42/EC
ENG902-1
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
3
6-2. Pad
6-3. Spindle
9-1. Exhaust vent
9-2. Inhalation vent
PW5000C,PW5000CH
M14
max. 125 mm
-1
2,000 - 4,400 min
313 mm
2.3 kg
/II
Corporation as the
ENH101-15
responsible