Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
sec.
04
...
sec.
5.7 - Manual adjustment of the UP limit switch height ("0") and the DOWN limit switch height ("1")
Caution! • When a request is made to send a command during the procedure, ONLY use a transmitter memorised using "Mode I" or a programming device from
among those available. • The two procedures can be performed one before the other, or vice versa, with no precise order.
5.7.1 - Adjustment of the UP limit switch height ("0")
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01. Stand opposite the awning/shutter; then identify, in the following Figure, the (A / B / C / D) scheme which corresponds to the characteristics of your installation: a)
where is the head of the motor: at the right hand edge or left-hand edge of the roller? b) where is the unrolled part of the awning/shutter with respect to the roller:
in front of or behind the roller?
02. Perform points 04 and 05 from the Figure below, choosing the procedure that matches the scheme chosen in point 01. Caution! – If at point 04 the awning/shut-
ter stops beyond the desired height for the limit switch "0", move the limit switch backwards by turning the adjustment screw in the opposite direction to that
shown in step 05. Then return to the procedure from point 04.
A
04
B
04
C
04
D
04
5.7.2 - Adjustment of the DOWN limit switch height ("1")
Before starting the procedure, bring the awning/shutter to a point half-way along its course.
01. Stand opposite the awning/shutter; then identify, in the following Figure, the (A / B / C / D) scheme which corresponds to the characteristics of your installation: a)
where is the head of the motor: at the right hand edge or left-hand edge of the roller? b) where is the unrolled part of the awning/shutter with respect to the roller:
in front of or behind the roller?
02. Perform points 04 and 05 from the Figure below, choosing the procedure that matches the scheme chosen in point 01. Caution! – If at point 04 the awning/shut-
ter stops beyond the desired height for the limit switch "1", move the limit switch backwards by turning the adjustment screw in the opposite direction to that
shown in step 05. Then return to the procedure from point 04.
5 – Inglese
2
...
05
...
05
...
05
...
05
...
2
sec.
3
6
sec.
Adjust to the height "0" desired
Adjust to the height "0" desired
Adjust to the height "0" desired
Adjust to the height "0" desired
2
sec.
...
3
"0"
"0"
"0"
"0"
...
...
...
...
Werbung
Inhaltsverzeichnis
