Adjusting Brake Levers; Checking Pads And Discs Of Front/Rear Brakes - Malaguti centro 125 ie Bedienungsanleitung

5.12 ADJUSTING BRAKE LEVERS

1
Maintenance of the brake levers is limited to the brake
2
A soft feeling in the brake levers could indicate
the presence of air in the hydraulic circuit. In
3
this event, refer to an Authorised MALAGUTI
Service Centre for a check and circuit purging, if
necessary.
4
5.13 CHECKING PADS AND DISCS OF FRONT/REAR
5
BRAKES
6
• We recommend that you check the front/rear pads
and discs every 2,000 km (1,250 mi).
• Check the thickness of the brake pads as indicated
by references A (front), B (rear) (Fig.33-34). The
minimum thickness of the brake lining shall not be
less than 2 mm (Fig.35).
• If the thickness of the pads is close to the lowest
permitted limit or if they are damaged, have them
replaced immediately.
ENG
It is absolutely necessary to replace the worn
discs and pads as soon as possible. This operation
must be performed by an Authorised MALAGUTI
Service Centre using only original MALAGUTI
spare parts.
36
chap.5.5).
A
B
Fig.33
Fig.34
MIN. 2mm
Fig.35