Alarm Operation - auna Wallie Bedienungsanleitung

ALARM OPERATION

Setting the alarm clock
This function allows the system to turn on automatically and wake you
using a beeping alarm, the CD, USB, BUZZER or RADIO.
1 In standby mode, hold the AL SET button (12) on the main unit for three
seconds, then alarm time "00:00" will appear on the display. Hour digits
of alarm clock start flashing.

2 Press the FORWARD or
press the AL SET button again to confirm, Minute digits will be flashing.

3 Press the FORWARD or
press the AL SET button again to confirm, alarm wake up source will
appear in display.

4 Press the FORWARD or
Buzzer or radio, and then press the AL SET button again to confirm,
alarm volume level will be flashing.
Note: Alarm volume level setting is not available in beeping alarm
setting.

5 Press the FORWARD or
alarm volume level and then press the AL SET button to finish alarm
setup.
Notes on the alarm function:
1 If "Wake to CD,USB" is selected but a CD ,USB is not inserted, the
alarm will default to the Beeping Alarm automatically when the alarm
wake time is reached.
2 For 'Wake to Radio", the system will default to the last radio station
listened to before switching off.
3 The volume of Alarm will be increased to the setting volume.
Active/de-active alarm function
1 To active ALARM, tap the AL SET button (12) once, the alarm icon "
will be shown on LCD display.
2 To cancel alarm function by tap again the AL SET button (12) until the
alarm icon " " goes off.

BACK buttons to set the hour and then

BACK buttons to set the minute and then

BACK buttons to select wake to CD, USB,

BACK buttons to preset the wake up
"
EN
45