Installation And Operation - auna DS-2 Bedienungsanleitung

EN
30

INSTALLATION AND OPERATION

Installation
• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the mains voltage
and before all other connections have been made.
• Do not cover any vents and make sure that there is a space of several
centimeters around the unit for ventilation.
Connections
• Connect the power cord (29) to ac outlet and connect the speaker jack
to the speaker socket (27) located on the rear side of unit.
• Press the power button (6) and if power led indicator (5) light up, it's
mean the power supply is normal. Now your system is ready to play the
music.
Setting the clock
1. Set unit in standby mode.
2. Press & hold the "mem/clk-adj" button (17), the lCD display (5) will show
" set clock " and then display " 12hr or 24 hr " press skip
button (2) to select the appropiate area hour format(12hr/24hr). Press
"mem/clk-adj" button (17) again to confirm.
3. The lCD (21) will display the first & second digit of "00" is flashing. Press
skip or skip
adj" button (17) to store the correct hour.
4. The third & fourth digit of "00" is flashing, press the skip
button (2) to set the correct minutes. Then press "mem/clk-adj" (17) to
store the correct minute.
Note: the pre-set time will be re-set completely if dis-connecting the main
power supply. You are recommended to switch the system into standby
mode for convenience usage.
button (2) to set the correct hour. Press "mem/clk-
or skip
or skip