Setup And Operation - auna MC-20 Bedienungsanleitung

SETUP AND OPERATION

Setup and operation
Carefully remove the appliance and accessories from the packaging and
check that the following accessories are also in the packaging:
• Operating Instructions
• Remote control
Power source
The unit runs on 100-240 V~ 50/60 Hz AC household power and requires
a CR2025 3V lithium battery for remote control, which is included. Before
switching on the unit, make sure that the mains plug is securely inserted in
the socket.
Remote control
The remote control runs on a CR2025 3V lithium battery, which is included
in the scope of delivery. To activate the remote control, remove the
protective film located in the battery compartment. If irregularities occur
during operation with the remote control or it no longer works properly,
replace the original battery with a new CR2025 3V lithium battery.
1. Press the battery cover down and pull the battery holder out of the
remote control housing.
2. Replace the battery and make sure it is inserted correctly. The remote
control will not work if the battery is inserted with the wrong polarity.
Caution: There is a risk of explosion if the battery is replaced incorrectly.
Only use the same or an equivalent type of battery.
Insert the battery holder into the battery compartment.
EN
35