Getting Started - auna Wallie Bedienungsanleitung

EN
36

GETTING STARTED

1) Installing back up batteries into the system
1 Remove the BATTERY DOOR.
2 Install 2 x "AA" (UM-3) batteries (not included) according to the polarity
diagram inside the battery compartment.
3 Close the BATTERY DOOR.
Note: The backup battery is only for the Clock Setting and cannot
backup the Alarm Setting.
2) Installing batteries into the remote control
The remote control operates on
one CR2025 battery (included).
To activate the remote control,
remove the insulation tab inserted
in the battery compartment.
When the operation of the remote
control becomes intermittent or
unsatisfactory, replace the original
battery with a new CR2025 lithium
battery.
1 Slide out the battery holder
from the remote control case.
2 Replace the 3V CR2025 battery.
Be sure the battery is installed
correctly. The remote will not work if the battery is installed with the
wrong polarity.
3 Insert the battery holder back into the battery slot.
WARNING: Do not ingest battery. Chemical burn hazard!
The remote control supplied with this product contains a
coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours
and can lead to death.
Keep new and used batteries away from children. If the battery
compartment does not close securely, stop using the product and keep it
away from children.
If you think batteries might have been swallowed or placed inside any part
of the body, seek immediate medical attention.