Nibe SMS 40 Installateurhandbuch Seite 15

Contact with SMS 40
SMS commands F1145/F1245
SMS 40 sends an SMS in the event of a power cut, when F1145/F1245 starts after a power cut and in the event of a
constant alarm.
SMS 40 can receive and send the following commands to F1145/F1245:
Command Answer
?status opmode: auto/add. heat only
reg1: -10-+10
reg2: -10-+10
reg3: -10-+10
reg4: -10-+10
tluxhw: on/off
vent: 0/1/2/3/4
vacat: on/off
?komp status: on/off
number of starts: nn
total operating time: nn
- of which hot water: nn
?temp flow nn
return nn
outd nn
indoor nn
calcf nn
DM nn
Bin nn
Bout nn
hw nn
*Accessories needed.
Description
Operating status
Temperature (Heating curve offset)
Temperature (Heating curve offset), climate system 2*
Temperature (Heating curve offset), climate system 3*
Temperature (Heating curve offset), climate system 4*
Temporary lux (hot water)
Fan speed. 0 = normal fan speed*
Holiday setting
Compressor status
Number of compressor starts
Total run time compressor and immersion heater?
Total run time hot water
Supply temperature
Return temp
Outdoor temperature
Indoor temperature. If the room temperature sensor is not installed/ac-
tivated, the following appears -
Calculated flow line temperature
Degree minutes
Incoming brine temperature
Outgoing brine temperature
Hot water temp.
GB
15