Program Settings; Technical Specifications - Nibe POOL 40 Installateurhandbuch

GB
Caution
The relay outputs on the accessory card can have
a max load of 2 A (230 V) in total.
Connection of the circulation pump, pool
circuit (GP9)
Connect the circulation pump (GP9) to AA5-X9:8 (230
V), AA5-X9:7 (N) and X1:3 (PE).
Unit box External
9
8
7
6
5
4
3
2
1
AA5-X9
1
2
3
X1
Connection of the circulation pump, climate
system (GP10)
If the climate system does not already have an external
pump, one can be connected to the accessory card.
Connect the circulation pump (GP10) to AA5-X9:2 (230
V), AA5-X9:1 (N) and X1:3 (PE).
Unit box External
4
3
2
1
AA5-X9
1
2
3
X1
Connection of the reversing valve motor
(QN19)
Connect the motor (QN19) to AA5-X9:6 (signal), AA5-
X9:5 (N) and AA5-X10:2 (230 V).
9
8
7
6
5
4
3
2
1
-X10
18
GP9
L
N
PE
GP10
DIP switch
The DIP switch on the accessory card must be set as fol-
lows.
Pool 1 Pool 2

Program settings

Program setting of POOL 40 can be performed via the
start guide or directly in the menu system.
Start guide
The start guide appears upon first start-up after heat
pump installation, but is also found in menu 5.7.
Menu system
If you do not make all settings via the start guide or need
to change any of the settings, this can be done in the
menu system.
Menu 5.2 - system settings
Activating/deactivating of accessories.
1) Applies to NIBE F1145 and F1245.
Menu 5.2.4 - accessories
Activating/deactivating of accessories.
2) Applies to NIBE F1345.
Menu 4.1.1 - pool
Activating pool heating and setting start and stop tem-
perature.
Menu 5.1.11 - pump speed heating medium
Setting heating medium pump's speed.
Caution
Also see the Installer manual for
F1145/F1245/F1345.

Technical specifications

Pool valve
Control voltage
KVS value
Connection valve (Ø mm)
AA5-S2
24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
-X8
-X2
-X4
1
2
3
4 -X10
5
6
-X1
7
8
1)
2)
230 V 50 Hz
8,6
28
-X9
9
8
7
6
5
4
3
2
1
N
L
PE
PE