Atag cubic Bedienungsanleitung Seite 23

operation
switching on
introduction
You can set the extraction capacity, brightness and continued
running time required on the control panel and erase the
memory of the grease filter indicator. On this and the following
pages you can read how to make use of the facilities.
switching on the extractor hood
Press the on/ off button.
The indicator light above the button lights up. You can now
use the other function buttons.
on/off button
switching the fan on
Press the fan button until the required setting has been
reached.
If you keep the button pressed, after a few seconds the
setting jumps one setting further (sequence 0-1-2-3-4-3-2-1-0).
fan button The indicator lights above the button show the setting.
intensive setting
Press the fan button until all the indicator lights above the
button light up.
When you release the button, the intensive setting switches
on.
intensive setting
switching the fan off
Press the fan button until all the indicator lights above the
button go out.
When you release the button, the fan switches off.
fan switched off
GB 6
automatic continued running
Press the continued running button until the time required is
shown.
You can choose to have the fan switch off after ten minutes
or twenty minutes. The time selected lights up above the
button. The extractor hood automatically switches down, in
continued running
button steps, from the setting entered to 0. If the lighting was
switched on during the continued running, it remains
switched on.
switching lighting on
1 Press the lighting button.
The lighting switches on at setting 4. The indicator lights
above the button show the setting.
2 Keep the lighting button pressed until the required
brightness has been reached.
lighting button
If you keep the button pressed, after a few seconds the
setting jumps one setting further (sequence
4-3-2-1-0-1-2-3-4).
switching lighting off
Press the lighting button until all the indicator lights above the
button have gone out.
switching extractor hood off
Switch the extractor hood off with the on/ off button.
The fan switches off and the lighting goes out.
on/off button
grease filter indicator
1 Clean the grease filters when the indicator light above the
grease filter button lights up (see page 8, "maintenance –
grease filters").
The filters are dishwasher-proof.
grease filter indicator 2 Put the clean filters back.
3 Erase the memory of the grease filter indicator by
button
keeping a finger on the grease filter button until the
indicator light goes out.
operation
switching on
GB 7