During Use - Atag cubic Bedienungsanleitung

safety
what you should pay attention to
general
This extractor hood is extremely safe. There are, however, a
number of things you have to pay attention to, just as for any
other product.
This appliance should only be connected by a registered
For safety tips in
relation to the installer.
installation, we refer
you to the Repairs should only be carried out by an authorised service
instructions in the engineer.
accompanying
installation guide. Never open the casing and do not alter the mechanical and/or
electrical structure of the appliance. This could result in
dangerous situations (touching live components) and faults.
Do not use the appliance if it is damaged.
The appliance should be disconnected from the mains before
being repaired or cleaned. Remove the plug from the socket
or turn the switch in the meter cupboard to zero.
For electrical safety reasons, the appliance must not be
cleaned using high-pressure cleaners or steam cleaners.
GB 4
what you should pay attention to

during use

Flambéing under an extractor hood is not permitted. The high
flames could cause a fire, even if the fan is switched off.
Always keep an eye on things when deep-frying.
Switch the extractor hood on before starting to cook. Leave
the extractor hood on for about ten minutes after you have
finished cooking. You can do this automatically (see page 7,
"operation – automatic continued running").
Clean the extractor hood regularly, as specified on page 8,
"maintenance". In this way, you prevent the risk of fire.
Disconnect the extractor hood from the mains before
replacing the light bulbs! Only use the same light bulbs, with
the wattage stated.
safety
GB 5