Product Identifier; Factory Default; Software Update - Philips DSR 300/00 Benutzerhandbuch

30 MENU
• LNB Freq. 2: set automatically according to the satellite
and LNB Type selected.
• Frequency: frequency value corresponding to the
selected transponder or entered manually using
numerical keys.
• Symbol Rate: symbol rate value corresponding to the
selected transponder or entered manually using
numerical keys.
• Polarization: Hor (horizontal) or Ver (vertical)
As you enter values, you can view the signal strength and
quality on the right-hand side of the screen.
7.7.4

Product Identifier

This feature is used to provide hardware and software
information.
7.7.5

Factory Default

To reset your receiver back to the factory default condition,
select Factory Default from the Installation sub-menu.The
Factory Default screen appears, displaying a warning
message. Press <OK> to confirm (selection is highlighted in
yellow).
Note: if you reset your receiver to factory default settings, you lose
all the data and information that was previously stored.
7.7.6

Software update

This feature is used to set the software download mode and
type.
To manage software downloads:
- Select Software update from the Installation sub-menu.
- Select the appropriate values for the followings:
• Select mode: Auto Mode or User Mode. It is
recommended to set the update mode to Auto Mode.
• Download Type: Software, Software+Data or Data
• For instance, data is a preset list.
- Press <OK> to launch a new software search.The
software search screen appears, displaying the search
progress and the new software version.