Makita EM2653LH Originalbetriebsanleitung Seite 20

REPLACEMENT OF ENGINE OIL
Deteriorated engine oil will shorten the life of the sliding and rotating parts to a great extent. Be sure to check the period and quantity of
replacement.
scald.
Interval of replacement: Initially, every 20 operating hours, and subsequently every 50 operating hours
Recommended oil:
In replacement, perform the following procedure.
2) Place large container (pan, etc.) under drain hole.
3) Remove drain bolt and then remove oil cap to drain out oil from drain hole.
At this time, be sure not to mislay drain bolt's gasket, or to dirty any of the
removed components.
4) Once all the oil has been drained, combine gasket and drain bolt, and tightly
secure drain bolt, so that it will not loosen and cause leaks.
* Use cloth to fully wipe off any oil attached to bolt and equipment.
Alternative draining method
Collect oil in container.
If oil cap is not tightly secured, it may leak.
Fuel tank cap
Internal stepped
section (upper
limit)
Internal stepped
section (lower
limit)
Upper limit mark
20
Oil cap
Oil cap
Drain hole
Gasket
Drain bolt
External mark
(upper limit)
External mark
(lower limit)
Oil