Memorization Of Radio Transmitters - Nice Rc2 Installierungs-Und Gebrauchsanleitungen Und Hinweise

MEMORIZATION OF RADIO TRANSMITTERS

A memorization procedure must be executed in order to enable the transmit-
ter to control the receiver.
WARNING:
• All the memorization sequences described in this chapter are timed, there-
fore they must be performed within the set time limits.
• All the receivers that are within the range of the transmitter can be memo-
rized via radio; it is therefore expedient to power only the receiver involved
in the operation.
You can check whether any transmitters have been previously memorized in
the receiver; this is done by counting the number of beeps emitted when the
receiver is switched on.
Checking the memorized transmitters
3 short beeps
2 long beeps
Two different procedures can be followed to memorize the transmitters:
– Mode I: simplified memorization (the transmitter keys are automatically
configured by the RC2 receiver).
– Mode II: advanced memorization (each single transmitter key can be con-
figured for a specific command).
— STEP 5 —
Some transmitters are already memorised
Empty memory (no memorized transmitters)
English – 5