Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
42 www.aeg.com
8.3 Rear spacers
8.4 Levelling
8.5 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
9. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
2
1
3
4
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.
Release the screw.
2.
Engage the spacer below the screw.
3.
Turn the spacer to the right position.
4.
Tighten again the screws.
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
8.6 Door reversibility
In case you want to change the opening
direction of the door, contact the near-
est After Sales Service Force. The After
Sales Service specialist will carry out the
reversibility of the doors at your cost.
8.7 Door reversibility
In case you want to change the opening
direction of the door, contact the near-
est After Sales Service Force. The After
Sales Service specialist will carry out the
reversibility of the doors at your cost.
Werbung
Inhaltsverzeichnis
